How To Light A Pilot Light On A Goodman Furnace

How To Light A Pilot Light On A Goodman Furnace. Once you are sure the pilot light is on, release your pressure All you need to do is locate the gas supply valve and rotate it in a counterclockwise direction to open it.

Pilot Light On Goodman Furnace Shelly Lighting
Pilot Light On Goodman Furnace Shelly Lighting from shellysavonlea.net

Subsequently, one may also ask, where is the pilot light on my furnace? Goodman furnace not igniting pilot issue doityourself com community forums. This may be the case if your goodman furnace won’t ignite, but the light is on continuously.

If Your Goodman Furnace Won’t Ignite, Then There Must Be A Reason For That.

Once the gas has had time to dissipate, turn the knob to pilot. then, hold down the reset button and bring the flame of a long lighter close to the pilot light opening. Then you light the pilot light and wait for the thermocouple to heat up (about 30 seconds). Open the access panel and look at the flue pipe system leading to the burners and pilot light.

Near The Bottom Of Your Furnace Is A Switch That Normally Says “Pilot,” “On” And “Off.” Find This Switch And Turn It To The “Off” Position.

This is usually red and should have settings for “off,” “on,” and “pilot.”. Turn the gas valve to the “off” setting. One of the most common culprits of a furnace that is having a difficult time lighting is a low gas supply.

Using A Flashlight If Necessary, Note The Small Pilot Gas Tube Leading From The Main Gas Valve And Extending Into The Burner Area;

Goodman furnace not igniting pilot issue doityourself com community forums. This is usually a white or red plastic knob that is on top of the main gas valve. Goodman furnace pilot light won t stay lit from www.decoratingspecial.com.

It Is Typically Located Either.

Likewise, how do i reset my furnace? Relight the pilot light with the ignition button, if your furnace has one. Open up the furnace and find the model number the number you are giving is a evaporator coil model number i believe if the furnace is the same age as this coil which is a 2006 according to the serial number then it is a self ignition system and.

If The Pilot Goes Out Again, Turn Off Your Furnace And Call A Trusted Hvac Company For Assistance.

It’s possible that the gas pilot light went out originally because your furnace has an issue that needs to be repaired. When you realize that you relight the pilot light, release the button. After locating the reset button, it’s time to turn the knob of the furnace to pilot.

Leave a Reply

Your email address will not be published.